Service Hotline
The following are the general steps for installing ceramic cylinder liners:
1. Preparation work
Clean installation area: Remove dirt, carbon deposits, and impurities inside the cylinder block to ensure a clean and flat installation surface.
Check the cylinder body: Check for cracks, wear, or other damage to the cylinder body. If there are any issues, repair them first.
Preparation tools: Prepare suitable installation tools as needed, such as press fit tools, wrenches, etc.
2. Apply lubricant
Apply an appropriate amount of lubricating oil or grease on the outer surface of the cylinder liner to reduce friction and resistance during installation.
3. Install cylinder liner
Carefully place the ceramic cylinder liner into the installation position of the cylinder block, ensuring that the orientation of the cylinder liner is correct.
Using a press fit tool, apply pressure evenly and slowly press the cylinder liner into the cylinder block until it is installed in place. Pay attention to keeping the cylinder liner vertical and horizontal during the pressing process, and avoid tilting or getting stuck.
4. Check the installation position
After installation, check whether the cylinder liner is fully in contact with the bottom of the cylinder block, and whether the top of the cylinder liner is flush with the plane of the cylinder block.
5. Subsequent processing
After installation, clean the excess lubricant around the cylinder liner and cylinder block.
It should be noted that ceramic cylinder liners of different types and specifications may have differences in installation methods and requirements. Before installation, it is essential to refer to the relevant installation instructions and technical specifications, and seek assistance from technical personnel if necessary.
